Solution : Use only on generally level ground. Possible cause : Driving conditions too stressful. Solution : The electrical switches can become corroded due to exposure to water or moisture, or can jam due to loose dirt, sand or gravel. Possible cause : Electrical switch damage. Solution : Visit the Dynacraft website and replace with a new motor. Make sure that there is power flow to the wall outlet. Check all connections. Make sure the charger port is plugged into the charging port on the electric dirt bike and that the charger is plugged into the wall outlet. Never charge the battery longer than 30 hours. After first-time use, recharge the battery for at least 12 hours after each use. Solution : Charge the battery. A new battery should have been charged for at least 18 hours before using the vehicle for the first time. Do not use non-original substitute parts. Replace only with an original 12 volt (10 amps/hour) battery with built-in thermal fuse. If your battery is old or if you have not followed Battery Care instructions, your battery may be dead. Solution : Check all wires and connectors. Make sure the battery connector is tightly plugged into the control module connector and that there are no loose wires around the motor. Solution : Replace with new battery. Replace only with an original 12 volt (10 amps/hour) battery with built-in thermal fuse. THE BATTERY’S THERMAL FUSE CONSTANTLY TRIPS, BUT THE VEHICLE IS NOT OVERLOADED AND THE DRIVING CONDITIONS ARE NOT SEVERE. Solution : Check all wires around the motors and all connectors to make sure they are tight. Possible caus e : Loose wire or connector. SOMETIMES THE VEHICLE DOESN’T RUN, BUT OTHER TIMES IT DOES. Do not drive up hills or run into fixed objects, which can cause the wheels to stop spinning while power is still being supplied to the motors. To avoid repeated automatic shutdowns, do not overload the vehicle by exceeding the 65 Ibs maximum weight capacity or by towing anything behind the vehicle. Once a fuse has tripped, release the foot pedal and wait 25 seconds before operating the vehicle again. Solution : The built-in thermal fuse may trip and shut down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe. Check all wires and connectors. Make sure the battery connector is tightly plugged into the control module connector, and that the charger is plugged into the wall. Average battery life is 1 to 3 years depending on vehicle use and use conditions. Solution : Even with proper care, a rechargeable battery does not last forever.
Battery buddy instructions full#
Possible cause : Battery is old and will not accept full charge. If you suspect that your battery is damaged as a result of overcharging, change with new original 12 volt (10 amps/hour) battery with built-in thermal fuse.
Solution : Do not charge the battery longer than 30 hours. SHORT RUN TIME (LESS THAN 15 MINUTES PER CHARGE). If your charger does not get warm during use, it does not mean that it is not working properly. Some chargers do not get warm during use. Possible cause : It is normal for some chargers to get warm during use and is not reason for concern. If your battery does not make noise or swell slightly while charging, it does not mean that it is not working properly.
Possible cause : It is normal for some batteries to make noise and swell slightly while charging and is not reason for concern. BATTERY MAKES A SIZZLING OR GURGLING NOISE WHEN CHARGING.
0 kommentar(er)
